The main function of the industrial chiller heater is to keep the water temperature constant and prevent cooling water from freezing. When the cooling water temperature is lower than the set one by 0.1℃, the heater starts to work. But when the heater of the laser chiller fails, do you know how to replace it?First, turn off the chiller, unplug its power cord, uncap the water supply inlet, remove the sheet metal casing, and find and unplug the heater terminal. Loosen the nut with a wrench and take out the heater. Take down its nut and rubber plug, and reinstall them on the new heater. Lastly, insert the heater back into the original place, tighten the nut and connect the heater wire to finish.

When using industrial chiller CW 5200, users should pay attention to cleaning the dust regularly and replacing the circulating water in time. Regular cleaning of dust can improve the chiller cooling efficiency, and timely replacement of the circulating water and keeping it at a suitable water level (within the green range) can prolong the chiller service life.First, press the button, open the dustproof plates on the left and right sides of the chiller, use an air gun to clean the dust accumulation area. The back of the chiller can check the water level, The circulating water should be controlled between red and yellow areas(within the green range).