What to do if the cooling fan of the chiller CW-3000 does not work?This may be caused by the low ambient temperature. The low ambient temperature keeps the water temperature below 20 ℃, thus leading to its malfunction. You can add some warm water through the water supply inlet, then remove the sheet metal, find the wiring terminal beside the fan, then re-plug the terminal and check the operation of the cooling fan. If the fan is rotating normally, the fault is solved. If it still does not rotate, please immediately contact our after-sales staff.

What to do if there is dust accumulation in the industrial chiller CW3000?10 seconds to help you solve this problem. First, remove the sheet metal, then use an air gun to clean the dust on the condenser. The condenser is an important cooling part of the chiller, and periodic dust cleaning is conducive to stable cooling. Follow me for more tips on chiller maintenance.

S&A mini industrial water chiller unit CW 3000 is a heat-dissipating chiller, with no compressor and no refrigerant. It uses high-speed fans to quickly dissipate heat to cool down the laser equipment. Its heat dissipation capacity is 50W/℃, meaning it can absorb 50W of heat by rising 1°C of water temperature. With simple structure, convenient operation, space saving, energy saving and environmental protection, mini laser chiller CW 3000 is widely used in cooling CO2 laser engraving and cutting machines.

What to do if the flow alarm rings in the industrial chiller CW 3000? 10 seconds to teach you to find the causes.Firstly, turn off the chiller, remove the sheet metal, unplug the water inlet pipe, and connect it to the water supply inlet. Turn on the chiller and touch the water pump, its vibration indicates the chiller works normally. Meanwhile, observe the water flow, if the water flow decreases, please immediately contact our after-sales staff.Follow me for more tips on the maintenance of chillers.

How to replace the cooling fan for CW-3000 chiller?First, turn off the chiller and unplug its power cord, uncap the water supply inlet, unscrew the fixing screws and remove the sheet metal, cut off the cable tie, distinguish the cooling fan’s wire and unplug it. Take away fixing clips on both sides of the fan, disconnect the fan’s ground wire, untighten the fixing screws to take out the fan from the side. Watch carefully the airfow direction when installing a new fan, don't install it backwards because the wind is blowing out of the chiller. Assemble the parts back the way you disassemble them. It is better to organize wires using a zip cable tie. Lastly, assemble the sheet metal back to finish.What else do you want to know about the maintenance of the chiller? Welcome to leave a message to us.